Civil Engineering interview questions and answers 11 to 15

11. What are the different type of slump test indications? 

Slump tests are performed to empirically measure the workability of fresh concrete. It is used to measure the consistency of the concrete. In general there are three different types of slumps that occur in slump tests.

They are as follows:
True Slump
Shear Slump
Collapse Slump

True Slump: This type of slump is characterized by the general drop of the concrete mass evenly without visible signs of deterioration or disintegration.

Shear Slump: It indicates that the concrete mix is deficient in cohesion. This type of slump leads to segregation and bleeding. Henceforth in the long run effecting the durability of the concrete.

Collapse Slump: This type of slump is indicates that the mix of concrete is simply too wet. The mix is considered to be harsh and lean.

12. Why is propping required for long structures once the formwork is removed? 

Once the process of concreting is performed the striking of the formworks should be done as soon as possible as delay in this process can lead to the discoloration of the concrete structures. In case of long structures particularly long span structures once the structures have attained enough strength to support themselves it is essential to provide them with propping as creep deflection can take place which can greatly reduce the integrity of the structure.

Due to the above mentioned reasons propping should be done after the removal of formwork. Also the props should not be made to stand long as it can lead to overstress for the structures.

13. Explain the mechanism of cavitations in pipes and drains? 

The formation of air bubbles in a fluid due to low pressure conditions lower than the saturation pressure is known as cavitations. This is considered to be a high potential damage condition where the strength and durability of the pipes can be greatly reduced. Cavitation works on the principle of Bernoulli's Equation.

When fluids are at high velocities the pressure head of fluids reduce accordingly. But since the fluid pressure is lower than the saturation pressure the dissolved gases get released from the flowing fluid. These air bubbles suddenly collapse on entering a region of high pressure. This leads to the damage of the pipelines as a high level of dynamic pressure is created.

14. For what purpose bedding is used under storm water drains, explain? 

Beddings are primarily made up of granular or concrete materials. They are primarily used for the following purposes:

They are used to provide a more uniform support for the under pipes so that the bending moment longitudinally can be reduced greatly.

In order to enable the pipes to get more load-supporting strength.

They are also used to act as a platform to achieve a more correct alignment and level pre and post construction.

In case of pipes which contain spigot and socket joints, it enables pipes to get supported along pipe lengths in place of sockets. Otherwise it can lead to uneven stress being induced on the pipes eventually damaging it.

15. Why are pull-out tests performed for soil nails? 

Pull out tests are performed for primarily the following reasons:

In order to detect and the verification of the bond strength among the soil and the grout adopted during the design of soil nails. This is considered to be as the primary objective of performing pull out tests for soil nails.

For the detection of any slippage or occurrence of creeps.

To detect the elastic and deformations (plastic) of any of the test nails employed. Observations are made during the loading and unloading cycles of the soil nails repetitively.

To achieve the perfect balance the test nails should always be loaded so that the ultimate soil/grout mixture with an upper limit of 80%.


Civil Engineering interview questions and answers 11 to 15 Civil Engineering interview questions and answers 11 to 15 Reviewed by Parag Pal on 7:51 AM Rating: 5

No comments:

Powered by Blogger.