Friday, 28 July 2017

Basic steps of Stadd-pro

In this blog I am going to discuss about STAADPRO as it is mostly use and better user Interface the steps involved are elaborated in following lines :

1. Creating a project file with suitable file name.
2. Fixing the units.
3. Creating the Geometry by JOINT   COORDINATES and MEMBER INCIDENCE command.
4. Applying the member properties as per codal provision and self judgement.
5. Providing support to the structure.
6. Using definition command for loads .
7. Applying loads on floors and other structural components.
8. Providing output units.
9. Defining the codes.
10. Print support reaction command after  perform analysis.
11. Defining design code i.e., IS 456 or IS 13920
11. Design commands as per respective codes
12 .Finally design and result output.

No comments:

Post a Comment